Nakanishi E3000 SELECTOR Operation Manual page 28

③ Output Signal
Refer to Fig. 28 regarding the Output Signal of the Rotating Pulse (PULSE). The output signal can be
connected for either sinking or sourcing.
Voltage and Current Speci¿cations
・Applied Voltage (V) ≦ DC+30V
・Working Current (lp) ≦ 50mA
④ Motor Speed Control Signal
Rotation Speed can be selected by, applying analog voltage to the " Motor Speed Control Voltage (VR) "
Refer to Fig. 29, 30 for connections. Refer to Fig. 31 about relationship between Motor Speed and " Motor
Speed Control Voltage (VR) ".
CAUTION
When applying the VR, never input more than DC+10V (Fig. 30). This will cause serious damag to
the I / O Board in the CONTROLLER.
The side of CONTROLLER
11
Vcc
Variable
23
Resistor VR
5KΩ
10
DC0V
Fig. 29
The side of CONTROLLER
Fig. 28
DC+24V or DC0V
18
(COM_2)
19
(PLUSE)
LOAD
DC0V or DC+24V
The side of CONTROLLER
23
VR
External
Control Signal
10
DC0V
Fig. 30
55