Nakanishi E3000 SELECTOR Operation Manual page 17

12 - 3 Connection of Motor Cord
CAUTION
Attach the provided Connector Cap (for Motor Output) for safety and dust proo¿ ng when not using
additional Motor Output Connector.
Connect to the Motor Cord Plug of the motor spindle to the Motor Output Connector 1 - 4 ( ③ , ⑤ , ⑦ , ⑨ ) on the
SELECTOR. (Refer to P42 " 11. MOTOR CORD CONNECTION " section.）
③ Motor Output Connector
⑤
Motor Output Connector
⑦
Motor Output Connector
⑨ Motor Output Connector
12 - 4 Connection of the Air Hose
(1) Connection to the Air Input Joint
CAUTION
When not using NAKANISHI Air Line Kit, make sure that the incoming air supply is dry, clean and
properly regulated.
6mm air hose with ¿ lter from the AL - C1204 Air Line Kit into the Air Input Joint ⑫ on the front
Insert the provided
of the SELECTOR.
(2) Connection of Air Output Joint
CAUTION
Attach the provided air plug (for air stoppage) for safety and dust proo¿ ng when not using the air
output joint on the CONTROLLER.
Insert one end of the provided
the SELECTOR. Insert another end of air hose to air joint at the rear of the motor spindle.
(3) Air Pressure Adjustment
Regulate air pressure 0.35MPa (50.8psi).
44
Fig. 17
4mm cooling air hose into the air Output Joint ( ④ , ⑥ , ⑧ , ⑩ ) on the front of
SELECTOR
Motor Cord Plug