Step 1 - Unpack And Inspect The Module; Step 1 - Unpack And Inspect The Modules; Esd; Inspect For Damage - Keysight Technologies M9391A PXIe Startup Manual

Step 1 - Unpack and Inspect the Module

Step 1 - Unpack and Inspect the Modules

ESD

Electrostatic discharge (ESD) can damage or destroy electronic components. Use a
static-safe work station to perform all work on electronic assemblies. The figure
(left) shows a static-safe work station using two types of ESD protection:
conductive table-mat and wrist-strap combination, and conductive floor-mat and
heel-strap combination. Both types, when used together, provide a significant level
of ESD protection. Of the two, only the table-mat and wrist-strap combination
provides adequate ESD protection when used alone. To ensure user safety, the
static-safe accessories must provide at least 1 MΩ of isolation from ground.

Inspect for Damage

After unpacking an instrument, inspect it for any shipping damage. Report any
damage to the shipping agent immediately, as such damage is not covered by the
warranty (see warranty information at beginning of this document).
Keysight M9391A PXIe Signal Analyzer & M9381A PXIe Vector Signal Generator 1 MHz to 3 GHz or 6 GHz
The modules are shipped in materials which prevent damage from static.
Modules should only be removed from the packaging in an anti-static area
ensuring that correct anti-static precautions are taken. Store all modules in
anti-static envelopes when not in use.
DO NOT use these techniques for a static-safe work station when working on
circuitry with a voltage potential greater than 500 volts.
To avoid damage when handling a module, do not touch exposed connector
pins.
16