Table of Contents
Advertisement
Chapter 3
Chapter 3
3-4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The Remote I/O Connector
The Remote I/O connector at the back of the PanelView 1200 terminal
connects the terminal to the host PLC controller via the Remote I/O link,
as shown in the following figure.
If the PanelView 1200 terminal is the last device on the link, connect a 1/2
watt terminating resistor across pins 1 and 2. The value of the resistor
depends on the Remote I/O baud rate:
for 57.6 kilobaud and 115.2 kilobaud, use a 150 resistor (A-B part
#740018-29)
for 230 kilobaud, use an 82 resistor (A-B part #740018-23)
Figure 1.4
Remote I/O Connector
The AC Power Connector
The PanelView 1200 terminal requires 115/230 VAC, 50/60 Hz.
Before connecting the power cable to the terminal, make sure the cable is
not carrying power. Since the PanelView 1200 terminal has no power
switch, connecting the AC power will start the terminal if power is present
in the cable.
Attention Incorrect power wire connection can cause personal
injury or damage to equipment.
20163
Advertisement
Table of Contents
