Table of Contents
Advertisement
16 characters fit in one touch cell
Button
Border
Objects, Windows, and PLC
Control Options
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The touch screen terminal contains 120 touch cells. Each touch cell is 2
characters high by 8 characters wide. You can configure the terminal to
beep when a touch cell is pressed.
Touch cells are grouped to create different types and sizes of buttons. The
following figure illustrates a single touch cell ON button with double
height and double width characters, and a solid border. You can activate
input functions by touching the appropriate object on the touch screen.
The objects, windows and PLC control options are listed in three groups:
those used on both keypad and touch screen terminals, those used for
keypad terminals only, and those used for touch screen terminals only.
You will note that the objects are identified as either dynamic or static.
Dynamic objects interact with the PLC controller; static objects do not.
For complete details on all objects, windows and options that can be
controlled from the PLC controller, refer to your PanelBuilder
Development Software User Manual, or your PanelBuilder 1200
Configuration Software for Windows User Manual.
The following table lists the objects, and indicates which terminal types
they are suited for. It also shows whether the object is dynamic or static.
Chapter 1
Introduction to PanelView 1200 Operator
Terminals
20002
20216
1-11
Advertisement
Table of Contents
