Appendix E - Open Source Disclaimer - Logic IO RTCU NX-200 Technical Manual

RTCU NX-200 Technical Manual V1.00
Advanced Automotive M2MI/IoT Gateway
1. Remove the frontplate by removing the three screws.
2. The jumper is located on the bottom side of the circuit board, near the audio jack connector.
3. Insert the jumper. Please pick a suitable jumper, that is not too long to conflict with the
endplate.
4. Place the frontplate, so the connectors fit the openings, then tighten the two screws.
Be careful not to tighten the screws too much, thereby damaging the aluminum.

Appendix E - Open Source Disclaimer

The RTCU NX-200 products include several open-source software tools. This open-source software
is governed by the terms and conditions of the applicable open source license, and you are bound
by the terms and conditions of the applicable open source license in connection with your use and
distribution of the open-source software in this product.
Please refer to the separate document "RTCU Open Source Licenses.pdf" for detailed information
about the packages used in the RTCU NX-200 product.
Logic IO ApS.
Holmboes Allé 14
8700 Horsens
Denmark
Jumper
Page 42 of 45
Ph: (+45) 7625 0210
Fax: (+45) 7625 0211
Email: support@logicio.com
www.logicio.com