ITS Telecom PanCam-C Installation And Programming Manual page 26

Programming
OPERATION
Delete a *360 + X + #
destination where:
number assigned X = 1 Day
to Day, Night, or X = 2 Night
Error DNs. This X = 3 Error
command must be
entered separately
for each X value
Defining the *441 + XXXX + #
digit(s) to open XXXX= Digits (0-9)
the door from any Note: Up to 4 digits
extension
Changing the *442 + 0XXX+#
Opening door 0XXX = New Access
Access Code Code up to four digits.
The first digit of the
access code in Speed-
dial mode must be 0.
If the new access code
is less than four
numeric digits, press the
# key following entry of
the digits. The
allowable characters are
0 through 9. Do not use
the * or # keys.
*For Outdoor *460 + X
units ONLY where:
Time between X = 1-9
DTMF's (each step is 200 msec)
Conversation time *462 + XX
limit (sec) XX = Seconds (10-99)
00 = Unlimited
Door opening *464 + X
time limit (sec) XX = Number of
seconds (1-9)
Changing the *600 + (new password)
programming Programming access
password passwords must be four
numeric digits. The
allowable characters are
0 through 9. Do not use
the * or # keys.
22 PanCam/Pantel/Pancode Installation and Programming Manual
COMMAND DEFAULT
8
0123
2 (400)
45 sec
3 sec
1234