ITS Telecom PanCam-C Installation And Programming Manual page 23

PBX Parameter Commands
OPERATION COMMAND
The Day/Night *360 + X + DN + #
DN will be dialed where:
X = 1 Day
when the Call
X = 2 Night
button is pressed,
X = 3 Error
respective to
Destination number
Day/Night mode.
(DN) = Up to 20 digits,
The Error DN is
including *, #, Pause,
dialed after
and A-D characters. For
receiving three
special character input,
invalid Access
see section 3.6 Entering
Code entries in a
Special DTMF
row
Characters.
Delete a *360 + X + #
destination where:
number assigned X = 1 Day
to Day, Night, or X = 2 Night
Error DNs. This X = 3 Error
command must be
entered separately
for each X value
Programming the *170 + prefix-digit(s) +
prefix-digit(s) for #
PBX extensions Maximum 4 digits
dialing. When (Do Not use * or # as
input to the prefix digit)
PanCam-C/
Pancode begins To cancel this
with these digits, operation, enter:
the PanCam-C/ *170 + #
Pancode will
process them as
extension dialing
Digit(s) to open *441 +XXXX + #
the door from any where:
extension XXXX= Digits (0-9)
Note: Up to 4 digits.
PanCam/Pantel/Pancode Installation and Programming Manual
Programming
DEFAULT
Day = 0
Night = 0
Error =
No default
No default
8
19