ITS Telecom PanCam-C Installation And Programming Manual page 25

Speed-Dial Setup
The following table contains programming functions, which
can be accessed in the programming mode for Speed-Dial
mode operation.
PBX Parameter Commands
OPERATION
Assigning a *120 + X + DN + #
Speed-dial X = a digit 1 through 9
destination DN = Destination
number. number (DN) = Up to
This command 20 digits, including *, #,
must be entered Pause, and A-D
separately for characters.
each X value For special character
input, see section 3.6
Entering Special DTMF
Characters.
Cancelling a *120 + X + #
Speed-dial X = a digit 1 through 9
destination
number.
This command
must be entered
separately for
each X value
The Day/Night *360 + X + DN + #
DN will be dialed where:
X = 1 Day
when the Call
X = 2 Night
button is pressed,
X = 3 Error
respective to
Destination number
Day/Night mode.
(DN) = Up to 20 digits,
The Error DN is
including *, #, Pause,
dialed after
and A-D characters. For
receiving three
special character input,
invalid Access
see section 3.6 Entering
Code entries in a
Special DTMF
row
Characters.
PanCam/Pantel/Pancode Installation and Programming Manual
Programming
COMMAND DEFAULT
No default
No default
Day = 0
Night = 0
Error =
No default
21