ITS Telecom PanCam-C Installation And Programming Manual page 24

Programming
OPERATION
Changing the *442 + (New Access
Opening door Code)
Access Code Access Codes can be up
to four numeric digits.
If the New Access Code
is less than four
numeric digits, press the
# following the entry of
the digits. Allowable
characters are 0 through
9. Do not use the * or #
keys.
Note: The access code
cannot begin with the
same prefix digits as
PBX extension numbers
*For Outdoor *460 + X
units ONLY where:
Time between X = 1-9
DTMF's (each step is 200 msec)
Conversation time *462 + XX
limit (sec) where:
XX = Seconds (10-99)
00 = Unlimited
Door opening *464 + X
time limit (sec) where:
X = Number of seconds
(1-9)
Changing the *600 + (new password)
programming Programming access
password password must be four
numeric digits.
Allowable characters
are 0 through 9. Do not
use the * or # keys.
*For PanCam-C *620 + X
ONLY X = 0 camera off
Camera X = 1 camera on
instructions X = 2 camera powered
when call button is
pressed
X = 3 camera powered
when any key is pressed
20 PanCam/Pantel/Pancode Installation and Programming Manual
COMMAND DEFAULT
9876
2 (400)
45 sec
3 sec
1234
0