Connecting A Smart Ops Pc Module; Viewing The Ops Pc Module Input - SMART Board 7000R Series User Manual

CHAPTER 4
CONNECTING COMPUTERS AND OTHER DEVICES

Connecting a SMART OPS PC module

If your organization has purchased a SMART OPS PC module, you or
your organization's installers can install the OPS PC module in the
accessory slot of the SMART Board 7000R or 7000R Pro series
interactive display following the OPS PC module's installation
instructions (smarttech.com/kb/171544). You can then view the OPS PC
module's input on the display.
For more information about the PCM8 series of SMART OPS PC
modules, see SMART OPS PC module on page 8.
CAUTION
Do not install the OPS PC module or remove it from the accessory slot while the display is turned
on.
TIP
You can install the SMART software that is included with the display on the OPS PC module. For
more information about installing software, see Installing and using SMART software on page 27.

Viewing the OPS PC module input

To view the OPS PC module input
1. Do one of the following:
If iQ is enabled
Tap the Home button
screen, and then tap Input
OR
Press the Input button
control.
A screen appears, showing thumbnails of the inputs connected to the display, including the
OPS PC module.
36 smarttech.com/kb/171539
If iQ is disabled
below the Tap the Home button
screen.
.
OR
Press the Home button
on the remote
button
below the
or the Input
on the remote control.