ARCURE Blaxtair 3 Installation Instructions Manual page 20

•
Use the buttons below to navigate :
It is possible to change the language from the "OSD" menu.
To display the camera(s) that should be active on power up, change the
"activated mode" line in the "System" menu.
Note: if required, the beeps can be turned off in this menu.
Examples:
•
Select "Dual 1" for a MR180 mono-monitor.
•
For a system with a front BxtView camera, the entry used on the
camera should be set to match the connector attached to the camera
(BxtView camera connected to "right/blue", activated mode on
"Right").
23/04/2019
« Up/Dn » for up/down
Right hand « Vol » to select a line.
20/71