Table of Contents
Advertisement
•
Install the Sensor Head (section 3)
•
Route the green Sensor Head
cable back to the Processor
location (section 5)
•
If no 'reverse signal' is available
near the Processor location it is
advisable to run a separate wire
along with the Head cable as the
Head will be situated close to a
reverse light or 'backup' alarm
•
Install the Power cable (section 7)
•
Mount the Monitor and any optional
Accessories (section 6)
•
Temporarily attach all cables to the
Processor (section 9)
•
Reconnect the power and turn
the ignition on. The Processor will
emit an audible signal to confirm
power is present
•
Check that the system 'starts up' correctly (section 10)
•
Power down the system then
finish installing the Processor
making sure that any excess
cables are neatly stored out
of sight
23/04/2019
10/71
Hide quick links:
Advertisement
Table of Contents
