When The Graphic Symbols Flash On The Touch Panel; Description Of The Flashing Graphic Symbols - Toshiba E-STUDIO 210C Operator's Manual For Copying Functions

Digital colour plain paper copier
Hide thumbs Also See for E-STUDIO 210C:
Table of Contents

Advertisement

1. DESCRIPTION OF THE FLASHING GRAPHIC SYMBOLS

The graphic display on the touch panel shows the
1
status of the copier. When one of the graphic sym-
bols flashes, take the appropriate action referring to
the page shown.
2
3
4
CHECK ORIGINALS
Flashes when an original misfeed occurs inside
the reversing automatic document feeder (op-
5
tional).
Page 9-9
BYPASS MISFEED
Flashes when a sheet of paper fails to be fed into
6
the copier during bypass copying.
REPLACE TONER CARTRIDGE
Flashes when the toner cartridge runs out of toner.
7
Page 9-5
PAPER PATH MISFEED
Flashes when a paper misfeed occurs on the
8
paper path inside the copier.
LARGE-CAPACITY FEEDER MISFEED
Flashes when paper fed from the large-capacity
9
feeder (optional) is misfed.
CASSETTE MISFEED
Flashes when paper fed from one of the cas-
10
settes is misfed.
STACK
Flashes when sheets of paper copied on one
11
side are stacked in the automatic duplexer (op-
tional) during duplex copying (this flashing does
not indicate a paper jam). This symbol also flashes
when sheets of paper are left in the duplexer. In
12
this case, remove the paper from the duplexer.
Page 9-16
9-2

WHEN THE GRAPHIC SYMBOLS FLASH ON THE TOUCH PANEL

symbol
symbol
Page 9-12
symbol
Page 9-12
Page 9-11
symbol
Page 9-10
symbol
DUPLEXER MISFEED
Flashes when a paper misfeed occurs inside the au-
tomatic duplexer (optional).
TRANSFER BELT MISFEED
Flashes when a misfeed occurs on the transfer belt.
Page 9-13
REPLACE TONER BAG
Flashes when the toner bag becomes full of used
symbol
toner.
Page 9-7
SADDLE STITCH UNIT MISFEED
Flashes when a paper misfeed occurs inside the
saddle stitch unit.
FUSER MISFEED
Flashes when a paper misfeed occurs in the fuser
symbol
unit.
Page9-14
FINISHER/PUNCHING UNIT MISFEED
Flashes when a paper misfeed occurs inside the fin-
isher (optional) or the hole punch unit (optional).
Page 9-17, 9-18
CALL SERVICE
Flashes when inspection and maintenance by a ser-
vice technician become necessary.
symbol
Page 9-15
symbol
symbol
symbol
Page 9-19
symbol
symbol
symbol
Page 9-28

Advertisement

Table of Contents
loading

This manual is also suitable for:

E-studio 310c

Table of Contents