Temperature Display - PerkinElmer FL 6500 Installation Instructions Manual

6. Set the parameters of for the probe, temperature and temperature display settings.
Probe Settings
Temperature settings
Monitor
Temperature(℃)
Range(℃)
Goto Temp
Auto Tuning
System Off
Temperature
Display
Save Settings
This function is used to adjust temperature. It is only used for the
manufacturing process, so do not modify the values.
Select the temperature used to monitor during measurement. Options
include: Block, Probe 1 or Probe2.
Enter the preset temperature for the experiment.
Starting temperature of experiment needs to be set up in the
NOTE:
method window.
Enter the error tolerance range.
After completing the parameter setup, select Goto Temp. Then the LED
for On-LINE is turned on and it will start heating up or cooling down to
the set temperature in the temperature settings.
This function is used to minimize the temperature fluctuation at the target
temperature. Refer to Pettier Temperature Controller Auto Tuning Setup
on page 23.
This function is used to stop the heating up or cooling down to the set
Temperature in the Temperature Settings.
Select which temperature will be displayed on the panel: Block, Probe 1 or
Probe 2. Note that the selected temperature is only displayed in real time.
Save the Probe, Temperature and Temperature Display setting
parameters.
20
09931519A