10.
Disconnect the hose for coolant circulation.
Figure 26 Disconnecting the hose for the coolant circulation
NOTE:
If you disconnect the hose, the remaining coolant in the hose may flow out of the hose. Be careful not to
touch the coolant with your bare hands.
11.
Connect the coolant inlet/outlet hosed and N
Controller 201 and the Single Cell Peltier Holder.
Figure 27 Connecting the coolant inlet/outlet and N
NOTE:
N
gas is not always required. If no gas is required, the user does not have to connect N
2
12.
Connect the temperature probe to the interface slot of the Single Cell Peltier Holder.
Figure 28 Connecting the temperature probe
gas tube between the Peltier Temperature
2
2
14
09931519A
gas fitting
gas tube.
2