Heat Sink - HP ENVY 13 Maintenance And Service Manual

Heat sink

Table 5-8 Heat sink and thermal pad descriptions and part numbers
Description
Heat sink for use in model with UMA graphics
Heat sink for use in models with discrete graphics
Thermal pads
Before removing the heat sink, follow these steps:
1.
Prepare the computer for disassembly
2.
Remove the bottom cover (see
3.
Remove the battery (see
4.
Remove the fan (see
Remove the heat sink on models with discrete graphics::
NOTE:
The heat sink can be removed without removing the system board.
1. Remove the conductive tape from the memory cover and the top of the heat sink (1). You do not have to
remove the tape from both covers to remove the heat sink.
2. Remove the six Phillips M2.0 × 3.0 screws (2) that secure the heat sink, and then remove the heat sink
from the system board (3).
34 Chapter 5 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
Bottom cover on page
Battery on page 27).
Fan on page 39).
24).
25).
Spare part number
L53387-001
L53388-001
L53392-001