HP ENVY 13 Maintenance And Service Manual page 57

e.
To remove the bottom bezel, use a non-marking, non-conductive tool to loosen the bezel from the
display (1), rotate the bezel away from the display (2), and then remove the bezel (3).
The bottom bezel is available using spare part number L54124-001.
5.
If it is necessary to remove the display cable from the display panel:
a.
Peel the large piece of tape that is installed over the display connector at the bottom of the panel
(1).
b. Peel the clear tape from the top of the display connector (2).
c. Disconnect the cable from the display panel (3).
d. (Touch screen models only) Remove the clear tape from the connector (4), and then disconnect the
cable from the touch control board (5).
Component replacement procedures 49