TouchPad
Table 5-5
TouchPad and cable descriptions and part numbers
Description
TouchPad in natural silver finish
TouchPad in pale gold finish
TouchPad cable
Before removing the TouchPad, follow these steps:
1.
Prepare the computer for disassembly
2.
Remove the bottom cover (see
3.
Disoonnect the battery (see
Remove the TouchPad:
1.
Disconnect the TouchPad cable from the ZIF connector on the system board (1).
2.
Remove the two Phillips M1.6 × 2.5 screws (2) and the two Phillips M2.0 × 3.0 screws (3) that secure the
TouchPad bracket to the computer, and then remove the bracket (4).
3.
Remove the three Phillips M2.0 × 2.0 screws (5) that secure the TouchPad to the computer, and then
remove the TouchPad (6).
Reverse this procedure to install the TouchPad.
(Preparation for disassembly on page
Bottom cover on page
Battery on page
27).
24).
25).
Component replacement procedures
Spare part number
L53393-001
L53394-001
L53364-001
31