Table of Contents
Advertisement
The Faema standard logos are shown on all the machine displays, after a period of inactivity set
for the "Screensaver" menu by the technician.
The machine is supplied with the logo shown in the image.
The user can replace it with another of the same size that will will appear on all displays (groups and
services), creating the file custlogo.bmp (maximum size 260 x 110 pixels).
To create a customised logo, proceed as follows:
1
Using any graphics program (e.g. Paint),
create a file that meets certain characteristics;
the prerequisites for a bitmap image to be
used as a custom logo are:
custlogo.bmp
• width less than or equal to 260 pixels;
• length less than or equal to 110 pixels.
• 24-bit bmp colour.
Copy into a USB pen drive the file
"custlogo.bmp" if the user wants to display
the on the services display.
4
Press OK and wait for the file to load:
Logo
2
Insert the USB pen drive in the
dedicated slot on the machine:
3
Turn the machine off and back on
again; when it comes back on the
following will appear on the services
display:
5
Once loading is complete, remove the USB pen drive from the machine.
At this point, the custom logo will be displayed
according to the settings programmed by the technical
staff.
Note: If the screensaver is active, it is possible
immediately see the logos, without waiting for idle time,
every time the user turns off the analogically gauge.
35 EN
the
icon will appear on the
services display:
Hide quick links:
Advertisement
Table of Contents
