Faema E71 E Engineer's Manual page 27

Coffee Boiler - this parameter includes
the entries for setting the temperature
of the coffee boilers, values that can
be set are 60 to 110°C (140 to 230°F)
in steps of 0.5°C. In this menu there is
also the possibility of programming an
offset of temperature for the boilers
which can be modified in a range of
+/- 2°C.
Softener Reg. - includes the
parameters for the resin regeneration:
resin litres (between 0.1l and 25l),
hardness (between 0 and 45 °F). The
decreasing resin efficiency level is
also indicated. Once the softener
regeneration has been performed,
press the icon to cancel the
message.
Change W. Filter - On reaching the litre
level set on the display a message is
displayed which prompts replacement
of the filter.
The efficiency percentage is displayed
(Softener/Filter) decreasing from
100% to 0%.
Once the filter has been replaced, push
the icon to cancel the message.
Maintenance - includes 4 submenus
for setting maintenance parameters:
- Max cycles - the number of cycles
set.
- Max days - the number of days set.
- No. cycles/days - this is the
number of cycles and days until next
maintenance.
- Maintenance - YES/NO.
Enables (YES) or does not enable
countdown of the cycles and days until
the next maintenance activity. O n c e
the maintenance has been performed,
press the icon to cancel the
message.
11. Programming
BDS - see section "BDS Activation" in
the following pages.
Flush - Not active.
Low power - YES/NO
Drying - Not active.
22 EN
Screensaver - Possibility of program-
ming the screensaver display time
(from 30" to 20')
Standard data - allows loading of
standard data or reconfiguration of the
machine. In both cases the machine is
automatically restarted.
Password- allows change of the code
for accessing technical programming.