Brake Flued - KYMCO MYROAD 700i Service Manual

3
. INSPECTION/ADJUSTMENT
BRAKE FLUID
＊
Do not mix different type of fluid, as
they are not compatible with each
other.
Do not allow foreign material to enter
the system when filling the reservoir.
Avoid spilling fluid on painted, plastic
or rubber parts. Place a rag over these
parts whenever the system is serviced.
Brake fluid level inspection:
With the scooter in an upright position, check
the front and rear fluid level. The level should
be above the lower level mark. If the level is
at or below the lower level mark "L", check
the brake pads for wear.
Worn break pads should be replaced
immediately. If the pads are not worn, have
your brake system inspected for leaks. Do not
ride your scooter unless the brakes are in
perfect working order.
Brake fluid type: DOT 4 (from a sealed
container)
Note: Other checks- Make sure there are no
fluid leaks. Check for deterioration or cracks
in the hoses and fittings.
3-19
MYROAD 700i