KYMCO MYROAD 700i Service Manual page 58

2
. FRAME COVERS/
EXHAUST MUFFLER
EXHAUST MUFFLER
REMOVAL
Disconnect the connector with O2 heater/O2
sensor.
Remove screws from muffler protector.
Loosen the rear muffler cover screws.
Remove the exhaust pipe joint nuts and
exhaust pipe.
Remove the muffler.
INSTALLATION
Replace the gaskets with new ones.
Install the exhaust pipe and tighten the joint
nuts.
Torque: 1.0~1.4 kg-m
Install the muffler and tighten the mount
bolts.
Torque: 3.2~3.8 kg-m
Install and tighten the band bolts.
Torque: 2.1 kg-m
2-19
Muffler protector
Screws
Bolt
MYROAD 700i
Bolt