Table of Contents
Advertisement
Installation and Operation, cont'd
4.
Repeat steps 2 and 3 on the other side of the YCS.
5.
Hold the unit with the attached brackets against the
underside of the table or other furniture. On the mounting
surface, mark the location of the bracket's screw holes.
6.
Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep in the mounting surface at the marked screw
locations.
7.
Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until slightly less
than 1/4" of the screw head protrudes.
8.
Align the mounting screws with the slots in the brackets
and place the unit against the surface, with the screws
through the bracket slots.
9.
Slide the unit slightly forward or back, then tighten all four
screws to secure it in place.
Projector mounting using the PMK 450
The Extron PMK 450 Multi-Product Projector Mounting Kit (part
#70-618-02 or #70-618-03) can accommodate multiple Extron
products of various sizes and their power supplies.
Front Plate (1)
Security Screw (2)
Extron
YCS SW2 A
Transcoding
Switcher
UT
OU
TP
S
TE
UT
2
RE
MO
T
INP
NT
AC
1
CO
2
L
1
UT
TP
OU
-SW
S
L
TO
INP
UT
AU
1
R
DIO
AU
R
VID
EO
2
WE
R
PO
12
V
X
A MA
VID
EO
0.4
O
S-V
IDE
Bottom Plate (1)
Figure 2-7 — Components of the Extron PMK 450 kit
2-8
YCS SW2 A • Installation and Operation
Top Plate (1)
Pipe Collar (1) and
Set Screws (4)
AC Power Cord
Access Slot
Rear Plate (1)
Filler Plate (1)
Two tools are included with the PMK 450 kit:
• A set-screw hex wrench
• A security screw hex wrench
To projector-mount the YCS SW2 A using the PMK 450,
1.
Unscrew the front and rear plates and the security screws
from the sides of the PMK 450.
2.
Slide the top and bottom plates apart.
3.
Loosen the four pipe collar set screws to allow the top
plate to move freely along the pole.
Ensure that the mounting pipe is installed with the cable
4.
access hole facing the rear, away from the projector screen.
5.
Slide the top plate up the pipe until the pipe collar is
positioned just above the cable access hole. Ensure the rear
of the top plate is facing to the rear, in the same direction as
the cable access hole in the pipe.
Pipe Collar and
Set Screws
FRONT
REAR
Figure 2-8 — Positioning the top plate on the pipe
6.
Level the top plate and secure it by fully tightening the set
screws. At least three screws must come in contact with
the pipe.
7.
Route the cables for the devices to be mounted so that the
cables exit the pipe through the cable access hole.
YCS SW2 A • Installation and Operation
2-9
Advertisement
Table of Contents
