SciCan STATIM 5000S Operator's Manual page 32

6. The Communication Port con't.
2. Place the printed wiring board back into position on the printer door. Note the alignment
of the mounting holes
door. The black plastic printer body rests between the locating ribs
the printer door.
3. Ensure that the flexible cables
and the wiring board.
4. Place the printer cover on the printer door. Ensure that the flexible cables are not pinched
between the cover and the door. The power button and the paper advance button must
protrude through the openings in the cover and operate freely.
5. Using a #1 Phillips screwdriver, secure the printer cover to the printer door with the three
screws retained during the disassembly procedure. Do not over-tighten these screws.
6. Plug your Statim 2000S / 5000S into the wall receptacle. Reconnect the printer if it was
previously disconnected. Turn the power switch to the ON position.
7. Press the printer power button to the ON position. Load paper into the printer following
the procedures in section 7.3 Installing Paper on the Internal Printer.
n
in the wiring board and the mounting bosses
9
n n
, are not pinched between the printer door
1 1 1 4
32
n
on the printer
1 3
n
on the inside of
10