Installation
1. Drill one 0.5"(12.7mm) hole at the central of the RFL200 / IP-RFL200 on mullion or wall
mount.
Route the cable of reader module through the central hole.
2. Drill one 0.39"(10mm) in right horizontal and 1.74"(44.4mm) in upper vertical through
the central hole.
And drill the other 0.33"(8.5mm) in left horizontal and 1.59"(40.6mm) in under vertical
through the central hole.
3. Push reader module on mullion or wall mount then install the main unit using two 6-32
or M3 screws.
4. Put the bezel on the reader module and then pushes it to fix up.
6
p.9