When A Product Is Initialized By Wiring The Cable - IDTECK iPASS IP-RFL200 User Manual

8

When a product is initialized by wiring the cable

1. As power off, make white, green and yellow wire are close.
2. As power on, all LEDs turn red or green color. After repeating on/off twice, they becom
e off.
3. As the LED off, only green LED turn on from the under to the top. All LEDs become gre
en.
4. RFL200 / IP-RFL200's buzzer sounds four times. It indicates to complete initialization.
5. After finishing to initialize, connect again white, green and yellow wire to a device whic
h had been basically connected as power off.
6. If turn on power, RFL200 / IP-RFL200 operates normally.
At this time, a card which had been first read on RFL200 / IP-RFL200 is registered as a m
aster card.
After registering a master card, the unit is automatically master mode.
When a product is initialized by wiring the cable p.16