IBM Power System POWER7 Series Common Service Procedures page 163

1. Enter diag at the command prompt.
2. Press Enter.
3. Select the Diagnostics Routines option.
4. When the Diagnostic Mode Selection menu is displayed, select System verification.
5. When the Diagnostic Selection menu is displayed, select the All Resources option or test the FRUs you
exchanged and any devices that are attached to the FRUs you exchanged by selecting the diagnostics for the
individual FRU.
Did the Resource Repair Action menu (801015) display?
No Continue with the next step.
Yes Go to step 9.
8. Did the Testing Complete, no trouble was found menu (801010) display?
Yes Use the Log Repair Action option, if not previously logged,
in the TASK SELECTION menu to update the AIX error log.
If the repair action was reseating a cable or adapter, select
the resource associated with that repair action.
If the resource associated with your action is not displayed
on the resource list, select sysplanar0.
Note: If the system attention indicator is on, this action will
set it back to the normal state.
Go to step 11 on page 150.
No If the original problem still exists, replace the FRU or
perform the isolation procedure that is next in the FRU list.
If you have reached the end of the FRU list, contact your
next level of support.
If a new problem occurs go to Beginning problem analysis.
9. When a test is run on a resource in system verification mode, that resource has an entry in the AIX
error log. If the test on that resource was successful, the Resource Repair Action menu is displayed.
After replacing a FRU, you must select the resource for that FRU from the Resource Repair Action
menu. This updates the AIX error log to indicate that a system-detectable FRU has been replaced.
Note: If the system attention indicator is on, this action will set it back to the normal state.
Perform the following steps:
1. Select the resource that has been replaced from the Resource
Repair Action menu. If the repair action was reseating a cable or
adapter, select the resource associated with that repair action. If
the resource associated with your action is not displayed on the
resource list, select sysplanar0.
2. Press Commit after you make your selections.
Did another Resource Repair Action (801015) display?
No If the No Trouble Found menu displays, go to step 11 on
page 150.
Continue with the next step.
Yes
The parent or child of the resource you just replaced might also require that you run the Resource
10.
Repair Action service aid on it.
Common service procedures
149