Canon DR-1210C Service Manual page 60

CHAPTER 3 DISASSEMBLY & ASSEMBLY
9. Eject Stopper
1) Open the eject stopper
While bending side
fitting parts and remove the eject stop-
3
per.
Figure 3-229
3-14
.
1
inward, unhook the
2
COPYRIGHT © 2006 CANON ELECTRONICS INC.
10. Operation Panel
Note: The operation panel is a component
included in the flatbed assembly.
When replacing it, be careful not to
make such foreign matters as paper
powder and dust fall into the flatbed
from gap. Do not remove any other
parts (upper cover, etc.) from the flat-
bed assembly.
1) Remove the 4 screws
self-tapping) on the bottom side.
Figure 3-230
CANON DR-1210C FIRST EDITION FEB. 2006
(M3 x L6,
1