Parts Procedures - Canon DR-1210C Service Manual

CHAPTER 3 DISASSEMBLY & ASSEMBLY
II. PARTS PROCEDURES
1. Feeder (Entire)
1) Disconnect the ADF connector
Figure 3-201
2) Open the feeder
straightly a little. Then slant it backwards
and remove it.
Note: Put the removed feeder on a clean
surface. Be careful not to damage or
soil the outer cover, the pressure board
and the feed unit.
Figure 3-202
3-2
.
1
1 . And lift the feeder up
COPYRIGHT © 2006 CANON ELECTRONICS INC.
2. Roller Unit/Separation Pad
Note: Refer to section in "CHAPTER 4, III.
MAINTENANCE" (P.4-12).
3. Pickup Tray
1) Open the feeder cover.
2) Open the document guide adapters
and remove the 2 screws
self-tapping).
Figure 3-203
CANON DR-1210C FIRST EDITION FEB. 2006
1
(M3 × L10,
2