Canon DR-1210C Service Manual page 58

CHAPTER 3 DISASSEMBLY & ASSEMBLY
6) Draw the cable
1
cover. Remove the 3 connectors
remove the ADF PCB
ble).
Note: Take care not to break the cables and
damage the wire insulations.
Figure 3-224
Note: For reassembling, hold the ground
cable first, then hold the hinge mounting
plate. In addition, insert the 2 sensor
cables in the correct connectors. The
red cable for document sensor must be
inserted in JDS1 (white) and the black
one for ADF sensor, in JDES1 (black).
3-12
out of the groove in the
and
2
(with ADF ca-
3
COPYRIGHT © 2006 CANON ELECTRONICS INC.
8. Feed Unit/Feed Motor
Note: The motor can be removed when dis-
assembling the feed unit.
1) Remove the ADF bottom cover.
2) Remove the hinge (left).
3) Remove the hinge mounting plate.
4) Remove the ADF PCB.
5) Draw the cables
the cover one by one. Then, remove the
(M3 × L6, self-tapping).
screw
2
Note: Take care not to break the cables and
damage the wire insulations.
Figure 3-225
CANON DR-1210C FIRST EDITION FEB. 2006
out of the groove in
1