CHAPTER 3 DISASSEMBLY & ASSEMBLY
7) Face the feeder surface upward again.
Using a tool having a thin, flat tip, press
down the fitting parts
cover
and unhook it. Make a gap be-
1
tween the ADF front cover and the ADF
top cover
.
3
Note: Do not press down the fitting parts too
much. It may damage them.
Figure 3-211
3-6
on the ADF front
2
COPYRIGHT © 2006 CANON ELECTRONICS INC.
8) Insert a tool having a thin, flat tip in the gap
around section A, slightly turn it and
1
unhook the fitting parts inside.
Then repeat the same action for section B
to enlarge the separation between the
ADF front cover and the ADF top cover.
Note: Take care when carrying out this step
as the outer surface of the cover is
damaged easily. It is recommended to
wrap the tool tip with cloth and so forth
for the cover protection.
Protection
material
Figure 3-212
CANON DR-1210C FIRST EDITION FEB. 2006