NAiS FP0 Series Hardware Manual page 78

Analog I/O Unit
4.1 Parts and Terminology
4.1.1 Analog Mode Switch Setting
Analog mode switch
Mode Switch
Range
number
Analog
0 to 5V
0 to 20mA
input input
1 to 3, 5
range
No averag-
ing
switching
(* Note 1)
1
2
3
5
ON
Analog
0 to
4
20mA
output output
range
switching
4
ON
. Notes
D (*1): No averaging: Conversion data is set for the specified input
D (*2): With averaging: On each channel, for each A/D conversion,
D (*3): If a thermocouple setting is used, averaging is carried out,
4.1.2 Analog I/O Terminal
Pin number
1
2
3
4
5
6
7
8
9
4 - 4
- 10 to +10V
No averag-
With aver- With aver-
ing
aging aging
(* Note 1)
(* Note 2) (* Note 2)
- 10 to
+10V
contact point area for each A/D conversion, on each channel.
the maximum and minimum values from the data of the
last ten times are excluded, and the data from the other
eight times is averaged, and the result set. (* section 4.7.1)
regardless of the switch settings. (* section 4.7.2)
Name
IN/V 0
IN/I 0
IN/COM
IN/V 1
IN/I 1
OUT/V
OUT/I
OUT/COM
K type thermocouple J type thermocouple
(* Note 3) (* Note 3)
Tempera- - 100 C to Tempera-
ture of tempera- ture of
terminal to ture of terminal to
1000 C terminal 750 C
Description
Analog input (channel 0), voltage input
Analog input (channel 0), current input
Analog input (channel 0 and 1), analog input
common
Analog input (channel 1), voltage input
Analog input (channel 1), current input
Ground for analog cable
Voltage output
Current output
Analog output common
Matsushita Automation Controls
FP0
T type thermocouple
(* Note 3)
- 100 C to Tempera- - 100 C to
tempera- ture of tempera-
ture of terminal to ture of
terminal 350 C terminal