NAiS FP0 Series Hardware Manual page 25

FP0
Status indicator LEDs
1 7 17 23
display the operation mode and error statuses (*section 2.1.1.1).
Mode switch
2 8 18 24
changes the operation mode (*section 2.1.1.2).
Tool port (RS232C)
3 9 19 25
is used to connect a programming tool (*section 2.1.1.3).
Power supply connector
4 10 20 26
Supply 24 V DC. It is connected using the power supply cable (AFP0581) that comes with the unit.
Input terminal (9-pin)
5
Output terminal (9-pin)
6
The input and output terminals (
(product number: 1840434) (*section 7.6).
Input connector (9-pin)
11
Output connector (9-pin)
12
The input and output connectors (
number: 51067 - 0900) (*section 7.7).
Expansion hook
13 16
is used to secure expansion units. The hook is also used for installation on FP0 flat type mounting
plate (AFP0804).
Expansion connector
14
connects an expansion unit to the internal circuit of the control unit (*section 6.1).
DIN rail attachment lever
15
allows simple attachment to a DIN rail.
The lever is also used for installation on FP0 slim type mounting plate (AFP0803).
Input connector (10-pin)
21
Output connector (10-pin)
22
Use a MIL type connector for the input and output connectors (
Input connectors (10-pin × 2)
27
Output connectors (10-pin × 2)
28
Use a MIL type connector for the input and output connectors (
RS232C port
29
Use this port to connect to devices with an RS232C port, such as an I.O.P., a bar code reader, or an
image checker, enabling data input and output. (*section 7.9).
Matsushita Automation Controls
7 8 9 10
and ) use a terminal block socket made by Phoenix Contact Co.
5 6
and ) use a connector made by Molex Japan Co. (product
11 12
16 17 18 19 20
23 24 25 26
Control Units
2.1 Parts and Terminology
and ) (*section 7.8).
21 22
and ) (*section 7.8).
27 28
2 - 5