Installation
6.2
Important Notes
D Measures regarding heat discharge
- Always install the unit orientated with the tool port facing
Tool port
- Do not install the FP0 control unit as shown below.
- Do not install the unit above devices which generate heat
6 - 6
outward on the bottom in order to prevent the generation of
heat.
Upside-down
Installation which
blocks the air duct
Horizontal installation of the unit
such as heaters, transformers or large scale resistors.
I/O connectors or I/O terminals on top
Installations such that the I/O
connectors or I/O terminals face down
Matsushita Automation Controls
FP0
. next page