NAiS FP0 Series Hardware Manual page 51

FP0
Power supply connector
1 4
Supply 24 V DC. It is connected using the power supply cable (AFP0581) that comes with the unit.
Input terminal (9-pin)
2
Output terminal (9-pin)
3
The input and output terminals (
(product number: 1840434) (*section 7.6).
Input connector (9-pin)
5
Output connector (9-pin)
6
The input and output connectors (
number: 51067-0900) (*section 7.7).
Input connector (10-pin)
7 11
Output connector (10-pin)
8 13
Input connector (10-pin × 2)
9 12
Output connector (10-pin × 2)
10 14
Use a MIL type connector for the input and output connectors (
Expansion hook
15 18
is used to secure expansion units.
Expansion connector
16
connects an expansion unit to the internal circuit of the expansion I/O unit (*section 6.1).
DIN rail attachment lever
17
allows simple attachment to a DIN rail.
The lever is also used for installation on FP0 slim type mounting plate (AFP0803).
Matsushita Automation Controls
4
and ) use a terminal block socket made by Phoenix Contact Co.
2 3
and ) use a connector made by Molex Japan Co. (product
5 6
11 12 13 14
18
Expansion I/O Units
3.1 Parts and Terminology
to ) (*section 7.8).
7 14
3 - 5