NAiS FP0 Series Hardware Manual page 32

Control Units
2.2 Specifications
Item Item
Special Pulse catch input
functions f ti
Interrupt input
RS232C port (* Note 1)
Periodical interrupt
Constant scan
High-speed counter
function
(* Note 2, 3)
Pulse
output
function function
(* Note
3)
2 - 12
Relay output type
C10RS/C10CRS
C10RM/C10CRM
Total 6 points
Available unit: FP0-C10CRS, C10CRM, C14CRS,
Baud rate: 300, 600, 1200, 2400. 4800, 9600, and
Transmission distance: 3m/9.84 ft.
Terminal block:
Communication method: half-duplex
0.5 ms to 30 s interval
Available
Counter mode: Addition/subtraction (one phase)
Counter mode: Two-phase/individual/direction decision
Output point ——————
number
Output ——————
frequency
C14RS/C14CRS
C14RM/C14CRM
X0 and X1: 50μs X0 and X1: 50μs
X2 to X5: 100μs
C14CRM, C16CT, C16CP, C32CT and
C32CP
19200 bps
3-pin, made by Phoenix Contact Co.
(product number: MKDS 1/3-3.5)
- Input point number: 4 channels maximum
- Maximum counting speed: 10 kHz maximum for
*
all 4 channels ( Note 4)
- Input contacts used:
- Minimum input pulse width: X0, X1.. 50 μs <10 kHz>
(two phase)
- Input point number: 2 channels maximum
- Maximum counting speed: 2 kHz maximum for all 2
channels
- Input contacts used:
- Minimum input pulse width: X0, X1.. 50 μs <10 kHz>
Matsushita Automation Controls
Transistor output
type
C16T/C16CT C32T/C32CT
C16P/C16CP C32P/C32CP
X0: count input (ch 0)
X1: count input (ch 1)
X2: reset input (* Note 5)
X3: count input (ch 2)
X4: count input (ch 3)
X5: reset input (* Note 5)
X3, X4 ..100 μs <5 kHz>
X0: count input (ch 0)
X1: count input (ch 0)
X2: reset input
X3: count input (ch 2)
X4: count input (ch 2)
X5: reset input
X3, X4 ..100 μs <5 kHz>
Two independent points
(Y0 and Y1)
(No interpolation function)
40 Hz to 10 kHz
(Y0/Y1: one-point output)
40 Hz to 5 kHz
(Y0/Y1: two-point output)
. next page
FP0