NAiS FP0 Series Hardware Manual page 126

Wiring
7.6 Wiring the Terminal Type
Procedure:
. Notes
D When removing the wire's insulation, be careful not to scratch
the core wire.
D Do not twist the wires to connect them.
D Do not solder the wires to connect them. The solder may
break due to vibration.
D After wiring, make sure stress is not applied to the wire.
D In the terminal block socket construction, if the wire closes
upon counter-clockwise rotation, the connection is faulty.
Disconnect the wire, check the terminal hole, and then
re-connect the wire.
7 - 14
1. Remove a portion of the wire's insulation.
7 mm/0.276 in.
2. Insert the wire into the terminal block socket until it
contacts the back of the block socket, and then
tighten the screw clockwise to fix the wire in place.
CORRECT
Wire
Suitable wire
Clockwise
Wire
Clockwise Counter
clockwise
Wire
INCORRECT
Matsushita Automation Controls
FP0