NAiS FP0 Series Hardware Manual page 128

Wiring
7.7 Wiring the MOLEX Connector Type
. Note
When removing a wire, use a flat-head screwdriver, or other
similar tool, to pull up the hold-down pin of the housing and then
pull out the wire.
7 - 16
2. Place the contact in the crimping tool, place the wire
in the contact and lightly squeeze the tool.
Crimping tool
3. Insert the crimped wire into the housing until it
contacts the back side.
Screwdriver
Pull up
Wire
Contact
Housing
Hold-down pin
Pull out
Wire
Matsushita Automation Controls
FP0