Huawei S5700 Series Hardware Description page 163

S5700 Series Ethernet Switches
Hardware Description
5
7
Port Description
10/100/1000BASE-T port
A 10/100/1000BASE-T Ethernet electrical port sends and receives service data at
10/100/1000 Mbit/s, and must use
10/100/1000BASE-T Ethernet electrical port.
Table 3-76 Attributes of a 10/100/1000BASE-T Ethernet electrical port
Attribute
Connector type
Standards
compliance
Working mode
Maximum
transmission
distance
10GE SFP+ port
A 10GE SFP+ Ethernet optical port supports auto-sensing to 1000 Mbit/s. It sends and
receives service data at 1000 Mbit/s or 10 Gbit/s.
10GE SFP+ Ethernet optical port.
Table 3-77 Attributes of a 10GE SFP+ port
Attribute
Connector type
Issue 24 (2016-08-12)
Ground screw
NOTE
It is used with a ground
Jack for AC terminal locking latch
NOTE
The AC terminal locking latch is not
delivered with the switch.
Description
RJ45
IEEE802.3, IEEE802.3u, IEEE802.3ab
10/100/1000 Mbit/s auto-sensing
Full-duplex
100 m
Description
LC/PC
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6
cable.
8
network cables.
Table 3-77
RPS socket
NOTE
l It is used with an RPS cable
hot swappable.
l A PoE switch can have an RPS power
supply connected to this socket to
provide inputs for system power supply
and PoE power supply. The two inputs
are independent of each other. The RPS
power supply can also be used as a
backup of the system power supply when
it does not provide PoE power.
AC socket
NOTE
It is used with an AC power
Table 3-76 describes the attributes of a
describes the attributes of a
3 Chassis
which is not
cable.
149