Optional Units and Expansion Boards
3-2 Installing Options and Expansion Boards
To avoid electric hazards, be sure to turn the PL's power OFF before installing
any optional units or expansion boards.
Use a screw driver to loosen or tighten the screws. Be careful not to over-tighten
any screws, since it may damage the equipment.
Be careful when removing or inserting any screws inside the body of the PL.
1
Attaching the PL's Support Leg
Be sure to remove the support "leg" when placing the PL into a panel or cabinet,
since this could damage either the leg, the PL or the panel.
In order to perform development using the PL-6700, an additional "leg" (support) is
supplied with the unit to stabilize it when placing it on a table top (i.e. when the unit
is not mounted in a panel), due to the irregular shape of the unit's chassis. The proce-
dure for attaching this leg is described below.
PL-6700 Series User's Manual
WARNING
1) Attach the support leg to the PL's
chassis, as shown here.
3 - 3