Setting - Toshiba V Series Operation Manual

• For safety, be sure to check that the base unit has been switched off before installing EN7 or
FN modules in it or removing them from it.
• For safety, do not touch the insides of the product except for the switches.
• For safety, do not disassemble the product.
• The static charged in the human body may cause the product to fail. Discharge the static
from the human body before setting the switches.
• In setting the switches, spread the electroconductive bag which contained the product or an
electroconductive mat, and place the product on it. Failure to observe this will damage the
product by the static.
• A strong force or other stress to the insides of the products may cause trouble. In setting the
switches, be careful not to touch the parts other than the switches with the tools or the like.
• In setting the switches, do not change other than the necessary settings. The wrong setting
will prevent the product from normal operation.
• Be sure to set an IP address type and a host ID.
• If the network parameters are downloaded to the EN7 or FN module, be sure to restart it.
The parameters will not be valid unless it is restarted.
• Verify transmission at the application level using the transmission protocol.
EN7 and FN modules do not permit use of the ports No. 10000 and No. 48000 for applica-
tions. Apart from them, the ports No. 50000 through No. 50999 cannot be used for FN mod-
ules. Use ports No. 1024 to No.65535 for user applications except for the reserved ports.
• If you have any question, contact the Toshiba service office concerned.
6F8C0878
Chapter 3 Setting
Warning
Caution
13