Planet WGR-500-4P User Manual page 54

Object
Host Name
MTU Size
Attain DNS Automatically
Set DNS Manually
Enable uPnP
Enable IGMP Proxy
Enable Ping Access on
WAN
Enable Web Server
Access on WAN
Enable IPSec pass
through on VPN
connection
Enable PPTP passthrough
on VPN connection
Enable L2TP passthrough
on VPN connection
Enable IPv6 passthrough
on VPN connection
If you get Address not found error when you access a Web site, it is likely that your DNS servers are
set up improperly. You should contact your ISP to get DNS server addresses.
WAN IP, whether obtained automatically or specified manually, should NOT be on the same
IP net segment as the LAN IP; otherwise, the router will not work properly. In case of
emergency, press the hardware-based "Reset" button.
User's Manual of WGR-500-4P and WGR-500-4PV
Enter your L2TP user name.
Password
Enter your L2TP password.
This option specifies the Host Name of the industrial wall-mount Gigabit
router.
The normal MTU (Maximum Transmission Unit) value for most Ethernet
networks is 1492 Bytes. It is not recommended that you change the default
MTU Size unless required by your ISP.
Select "Attain DNS Automatically", the DNS servers will be assigned
dynamically from your ISP.
If your ISP gives you one or two DNS addresses, select Set DNS Manually
and enter the primary and secondary addresses into the correct fields.
Check the box to enable the uPnP function.
Check the box to enable the IGMP Proxy function.
Check the box to enable Ping access from the Internet Network.
Check the box to enable the web server access of the Industrial wall-mount
Gigabit router from the Internet network.
Check the box to enable IPSec passthrough function on VPN connection.
Check the box to enable PPTP passthrough function on VPN connection.
Check the box to enable L2TP passthrough function on VPN connection.
Check the box to enable IPv6 passthrough function on VPN connection.
54
Description