Display Ntdp Single-Device Mac-Address - H3C S3100 Series Command Manual

Command Manual (For Soliton) – Stack-Cluster
H3C S3100 Series Ethernet Switches

2.4.6 display ntdp single-device mac-address

Syntax
display ntdp single-device mac-address mac-address
View
Any view
Parameters
mac-address: MAC address of the device whose detailed information is to be
displayed.
Description
Use the display ntdp single-device mac-address command to display the detailed
information, which is collected through NTDP protocol packets, about a single device.
The information displayed by the command is similar to that displayed by the display
cluster members command. However, if you want to display information about a
device that is enabled with only NTDP and is not in any cluster, you have to use the
display ntdp single-device mac-address command.
Examples
# Display the detailed information about the switch with the MAC address
000f-e200-3956.
<Sysname> display ntdp single-device mac-address 000f-e200-3956
Hostname
MAC
Hop
Platform
IP
Version:
H3C Comware Platform Software.
Comware Software, Version 3.10
Copyright(c) 2004-2007 Hangzhou H3C Tech. Co., Ltd. All rights reserved.
S3100-26TP-EI-W S3100-26TP-EI-W-1545
Cluster
Peer MAC
000f-e239-1333
: H3C
: 000f-e200-3956
: 0
: H3C S3100-26TP-EI-W
:
: Candidate switch
Peer Port ID
Ethernet1/0/4
Chapter 2 HGMP V2 Configuration
Native Port ID
Ethernet1/0/10
2-51
Commands
Speed Duplex
100 FULL