Stacking Enable - H3C S3100 Series Command Manual

Command Manual (For Soliton) – Stack-Cluster
H3C S3100 Series Ethernet Switches
You can use this command to switch from user view of the main switch to user view of a
slave switch. To switch from a slave switch back to the main switch, execute the quit
command in user view.
Example
# Switch from the main switch Sysname to the slave switch numbered 1 and then
switch back to the main switch.
<stack_0.Sysname> stacking 1
<stack_1.Sysname>
<stack_1.Sysname> quit
<stack_0.Sysname>

1.1.4 stacking enable

Syntax
stacking enable
undo stacking enable
View
System view
Parameter
None
Description
Use the stacking enable command to create a stack.
Use the undo stacking enable command to remove a stack.
The stacking enable command triggers a main switch to add the switches connected
to its stack ports to the stack.
The undo stacking enable command can only be executed on a main switch.
A slave switch quits the stack automatically when it is disconnected from the stack.
Note:
Remove the IP address configured for the existing Layer 3 interface first if you want to
cancel the stack-related configuration, otherwise, IP address conflicts may occur.
Example
# Create a stack.
Chapter 1 Stack Function Configuration
1-4
Commands