Tftp-Server - H3C S3100 Series Command Manual

Command Manual (For Soliton) – Stack-Cluster
H3C S3100 Series Ethernet Switches
Related commands: tftp get,tftp-server.
Note:
You need to specify the cluster keyword completely in the command.
For description of other parameters of the tftp command, refer to the
FTP-SFTP-TFTP part of the manual.
Examples
# Upload file config.cfg on the switch to the shared TFTP server of the cluster and
save it as temp.cfg.
<123_1.Sysname> tftp cluster put config.cfg temp.cfg

2.3.24 tftp-server

Syntax
tftp-server ip-address
undo tftp-server
View
Cluster view
Parameters
ip-address: IP address of a TFTP server to be configured for the cluster.
Description
Use the tftp-server command to configure a shared TFTP server for the cluster on the
management device.
Use the undo tftp-server command to remove the shared TFTP server setting.
By default, no shared TFTP server is configured.
After the IP address of the shared TFTP server is configured, NAT is enabled on the
management device immediately. When a member device uses the tftp cluster get or
tftp cluster put command to download or upload a file from the shared TFTP server,
the management device translates the private IP address of the member device to a
public network address, forwards the requests of the member device to the TFTP
server, and forwards the responses of TFTP server to the member device according to
the NAT record.
Note that you can only use the commands on a management device.
Chapter 2 HGMP V2 Configuration
2-42
Commands