Cluster Switch-To - H3C S3100 Series Command Manual

Command Manual (For Soliton) – Stack-Cluster
H3C S3100 Series Ethernet Switches
Use the undo cluster enable command to disable the cluster function.
By default, the cluster function is enabled.
Note that:
To create a cluster on a management device through the build command or the
auto-build command, you must first enable the cluster function by executing the
cluster enable command.
When you execute the undo cluster enable command on the management
device, the cluster function is disabled on the device, and the device stops
operating as a management device, and the cluster and all its members are
removed.
When you execute the undo cluster enable command on a member device, the
cluster function is disabled on the device, and the device leaves the cluster.
When you execute undo cluster enable command on a device that does not
belong to any cluster, the cluster function is disabled on the device, and thus you
cannot create a cluster on the device or add the device to an existing cluster.
Examples
# Enable the cluster function on the switch.
<Sysname> system-view
System View: return to User View with Ctrl+Z
[Sysname] cluster enable

2.3.7 cluster switch-to

Syntax
cluster switch-to { member-number | mac-address H-H-H | administrator }
View
User view
Parameters
member-number: Member number of a member device, ranging from 1 to 255.
mac-address H-H-H: Specifies the MAC address of a member device.
administrator: Switches back from the member device to the management device.
Description
Use the cluster switch-to command to switch between the management device and a
member device for configuration and management.
On the management device, you can switch to the view of a member device to
configure and manage the member device, and then switch back to the management
device.
Chapter 2 HGMP V2 Configuration
2-23
Commands