Restore Factory Settings; Maintenance And Cleaning - Homematic IP HmIP-FALMOT-C12 Installation Instructions And Operating Manual

11

Restore factory settings

The factory settings of the device can be re-
stored. If you do this, you will lose all your set-
tings.
To restore the factory settings of the floor heating
actuator, please proceed as follows:
• Press and hold down the system button (A) for 4
seconds until the LED (A) quickly starts flashing
orange (see figure 6).
• Release the system button again.
• Press and hold down the system button again for
4 seconds, until the status LED lights up green.
• Release the system button to finish the proce-
dure.
The device will perform a restart. After the restart, you
can again integrate your device into your Homematic IP
system.
12

Maintenance and cleaning

The product does not require any maintenance.
Enlist the help of an expert to carry out any main-
tenance or repairs.
Clean the device using a soft, lint-free cloth that is clean
and dry. Do not use any detergents containing solvents,
Restore factory settings
69