Restore Factory Settings - Homematic IP HmIP-Set-5 Installation Instructions And Operating Manual

1x long red
lighting
6x long red
flashing
1x orange and
1 x green light-
ing
9

Restore factory settings

The factory settings of the device can be re-
stored. If you do this, you will lose all your set-
tings.
To restore the factory settings of the blind actuator,
please proceed as follows:
• Remove the rocker (if necessary).
Press and hold down the system button (A) for 4
•
s with a pointed object (e.g. a pen) until the LED
will start flashing orange quickly (see figure 10).
• Release the system button again.
• Press and hold down the system button again for
Transmission
failed or duty
cycle limit is
reached
Device
defective
Test display
Restore factory settings
Please try again (see
sec. „8.1 Command
not confirmed" on
page 48 or „8.2 Duty
cycle" on page 48).
Please see your app
for error message or
contact your retailer.
Once the test
display has stopped,
you can continue.
51