Behaviour After Switching On The Mains Voltage - Homematic IP HmIP-FALMOT-C12 Installation Instructions And Operating Manual

Open the cover (E) by pulling it downwards (see
•
figure 5).
• Connect (optionally) a 24 V
to the terminal (H). To connect and disconnect
the individual wires, press the orange actuator
button using a small screwdriver.
• Connect the connecting cables of the valve ac-
tuators of your heating circuits to the connecting
sockets (I).
• Connect (optionally) the connecting cable of
your expansion box to the connecting socket (J).
• Close the cover again by placing the cover in the
guide rail provided and pushing the cover up-
wards.
• Plug the power cable (optional) into a socket.
6.3 Behaviour after switching on the mains
voltage
After the mains voltage is switched on, the display
(B) lights up permanently.
If the device has not yet been connected, teach-in mode
will be activated during the first 3 minutes after the mains
voltage has been switched on. You will find further infor-
mation about connecting your device in the next section.
All connected valve actuators are opened fully one after
the other. The valve actuators then carry out an adaptati-
on run to determine the valve closing position.
connecting cable
DC
Start-up
51